PERFORMANCE FOR MOVING EQUIPMENT

Precision Stock Shapes for Machinery Components.

Industrial machinery components must manage repeated motion, mechanical load, impact, vibration, temperature and exposure to lubricants or process chemicals.

Engineering plastics can replace selected metal parts to reduce mass, noise and lubrication demand while improving corrosion resistance and protecting mating surfaces.

ZERO supplies semi-finished rods and sheets for further machining. Material selection should be based on actual pressure, speed, temperature, environment, tolerance and expected service life.

MOTION & WEAR
Material selection around friction, speed, pressure and service life.

PRECISION & STABILITY
Stock shapes prepared for accurate machining and repeat production.

MACHINERY PERFORMANCE REQUIREMENTS

Properties That Influence Reliability and Service Life.

The best material balances motion, load, environment and manufacturability rather than relying on one headline property.

01 · WEAR

Wear Resistance

Support sliding and rolling parts exposed to repeated contact and abrasive conditions.

02 · FRICTION

Low Friction

Reduce drag, stick-slip, noise and dependence on external lubrication where appropriate.

03 · LOAD

Mechanical Strength

Carry static, cyclic and impact loads within the component’s geometry and safety factor.

04 · STABILITY

Dimensional Stability

Maintain clearances, alignment and accurate features through operating changes.

05 · CHEMICAL

Chemical Resistance

Evaluate lubricants, coolants, cleaning agents and process chemicals at service temperature.

06 · MACHINING

Precision Machinability

Enable complex replacement parts, prototypes and repeatable production dimensions.

TYPICAL COMPONENTS

Machined Parts for Motion, Support and Handling.

Component geometry, counterface, lubrication, alignment and operating cycle all affect material performance.

01 / ROTATION

Bearings & Bushings

Low-friction support parts for shafts, pivots and rotating assemblies.

02 / DRIVE

Gears & Sprockets

Lightweight drive components for controlled loads, speeds and temperatures.

03 / GUIDANCE

Guides & Wear Strips

Sliding surfaces for conveyors, production lines and positioning systems.

04 / HANDLING

Rollers & Pulleys

Corrosion-resistant handling components with reduced rotating mass.

05 / PROTECTION

Scrapers & Seal Supports

Close-tolerance parts for debris control, wiping and seal positioning.

MACHINERY APPLICATION FAQ

Before Replacing a Metal Machinery Part.

Review the complete operating system, not only the original component dimensions.

Potential benefits include lower mass, reduced noise, corrosion resistance, electrical insulation, protection of mating surfaces and less lubrication. Suitability depends on load, temperature, stiffness and dimensional requirements.

There is no universal choice. POM, PA6, PET, PEEK and modified bearing grades suit different pressure, speed, temperature, moisture, chemical and lubrication conditions.

Some designs may operate with little or no external lubrication, but gear geometry, load, speed, temperature, mating gear, noise and target life must be evaluated together.

Moisture absorption can change dimensions and properties in some materials, especially polyamides. Define humidity or water exposure and required tolerances before selection.

Please provide the drawing, component function, load, speed, duty cycle, temperature, chemicals, lubrication, mating material, tolerances, stock dimensions and quantity.